SHELLS:

CABLE PLUGS: FGG, FHG, FNG, FFG, FMG
PANEL MT PLUGS: FAG, FWG , YHG (water tight / sealed)

BRIDGE PLUGS: CFF, CRG, FTG

CABLE RECEPTACLES: PHG, PNG

PANEL MT RECEPTACLES:  EGG, ECG, ENG, EHG, EPG, EXG, EEG

PANEL MT RECEPTACLES:  HNG, HGG, HHG, HCG, HMG (water tight / sealed)

PANEL MT RECEPTACLES W/CABLE COLLET:  PKG, PFG, PEG

FIXED COUPLERS:  Rxx, Sxx (water tight / sealed)

INSERT TYPES:

“3” = Multi-Pin, “7” = Mixed: High Voltage & Signal Pins,
“8” = Mixed: Coax & Signal Pins

OUTERSHELL MATERIALS:

“C” = White Chrome Matt Finish, “N” = Nickel Matt Finish, “L” = Aluminum,
“X” = Avional, “G” = PEEK, “K” = Black Chrome Matt Finish,
“S” = Stainless Steel Outershell & Back Nut
“T” = Stainless Steel Latch Sleeve & BackNut
“U” = Stainless Steel Connector (all components)

INSERT MATERIALS:

“L” = PEEK (“N” = PBT / VALOX – this material was discontinued in 1992.  Sometimes it is available, but we recommend using PEEK.)

CONTACT TYPES:

MALE: “A” = Male Solder, “C” = Male Crimp, “D” = Male Straight PC
FEMALE: “L” = Female Solder, “M” = Female Crimp,
“N” = Female Straight PC, “V” = Female 90* PC

COLLETS FOR CABLE CONNECTORS (ONLY):

“D” = Standard Sized Collet & Back Nut
“M” = Reduced Sized Collet & Back Nut (reduces rear of connector down 2 sizes)
(NOTE: To specify the correct collet size of your connector you will need the total outside diameter of the cable that will be used.)

VARIANT:

(1) “Z” = Build of Materials requires a Bend Relief Back Nut (applies to cable connectors only)
(2) Color Designators For Anodized Aluminum Shells & Back Nuts:
“T” = Natural, “N” = Black, “A” = Blue, “R” = Red, “G” = Green
(3) Cable Group (applies only to “8” = Mixed, Coax & Signal Pin inserts)

Lemo ^® is a registered trademark of Lemo S.A. Switzerland

[Back to Technical Information Page]
[Lemo® B Series Dimensions]
[Lemo® B Series Guidelines]
[Lemo® B Series Numbering]
[Lemo® B Series Photos]